Nostalgia-electrics CCP610 User Manual Page 11

  • Download
  • Add to my manuals
  • Print
  • Page
    / 40
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 10
ENGLISH
9
HOW TO OPERATE
Before rst use, clean the inside of the unit by wiping with a moist, non-abrasive
sponge, towel or cloth and then wipe with a non-abrasive dry towel. Wipe down the
inside of the Kettle and be sure it is properly placed in the brackets before starting.
1. First, nd a at surface near an electrical outlet before starting. Make sure your cord
is away from any water source. It is acceptable to use an extension cord if needed.
2. Gather your popcorn making supplies: popcorn, seasonings, bowls or bags for
holding the popcorn, cooking oil, Kernel Measuring Cup and Oil Measuring Spoon.
(Kernel Measuring Cup and Oil Measuring Spoon are included with your unit).
3. Make sure Kettle is properly secured in support brackets.
4. Make sure Kettle motor is fully plugged into the outlet located on the bottom
side of the kettle. NOTE: Kettle will not heat if plug is not fully inserted.
5. Plug in the appliance while switch is ipped to OFF position.
6. Turn appliance ON by ipping the switch on the top of the machine (see illustration above
for location of switches). Allow the appliance to run 3-5 minutes to heat up Kettle.
7. Once Kettle has heated, turn unit OFF before adding ingredients.
8. Use the Oil Measuring Spoon (D) supplied with your OLD FASHIONED™ MOVIE TIME
POPCORN CART with CONCESSION STAND to add 1 tablespoon of your favorite popcorn
cooking oil to the Kettle. For best popping results, it is suggested to use light vegetable oil.
9. Add popcorn kernels to the Kettle using supplied Kernel Measuring Cup (B).
NOTE: If you are using pre-measured packages of corn kernels or popcorn
making kits, you must still measure out the corn kernels and oil using the
supplied Kernel Measuring Cup (B) and Oil Measuring Spoon (D). Always
follow this rule: 1 Tbsp. oil + 2oz. popcorn = 8 cups popcorn.
10. Close the door and turn unit ON. Turning the light switch to the ON
position to turn on the light and activate the Warmer.
11. In no time at all, you will hear the popping begin. Fresh, hot popcorn will
begin to burst out of the ip lids on the Kettle - just like at the theater!
Crank Handle
ON/OFF &
Light Switches
(rear)
Stainless
Steel Kettle
Tilt Door (rear)
Page view 10
1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 39 40

Comments to this Manuals

No comments